Flip, funnel or roll in any room of your house with the incredible Blade® Nano CP X. At just 29 grams (barely over an ounce), it’s the lightest flybarless CP heli in. WARNUNG: Lesen Sie die GESAMTE Bedienungsanleitung, um sich vor dem. Betrieb mit den Blade Nano CPS. Inklusive registrieren. Step by step DX6 / DX9 for nano This is done in the style from the DX6i for From the nano CPX manual the derives settings from DX8/DX18 are: .. you should see the blades twist and the swash move up and down level.
|Published (Last):||7 August 2004|
|PDF File Size:||13.67 Mb|
|ePub File Size:||15.56 Mb|
|Price:||Free* [*Free Regsitration Required]|
For up-to-date product literature, visit horizonhobby.
BNF Blade 500 3D Instruction Manual
Meaning of Special Language The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: The purpose of safety symbols is to atttract your attention to possible dangers.
This helicopter cps equipped with carbon fiber blades that spin at very high RPM.
Always follow all safety precautions found in this manual. Use only Horizon Hobby approved battery packs and chargers compatible with this product.
Never leave the battery and charger unattended during the charge process. Failure to follow the instructions properly could result in a fire. When charging, ensure anleifung battery is on a heat-resistant surface. Charge the flight battery before binding the If charging or discharging, discontinue and disconnect.
Continuing to use, charge or discharge a battery that is ballooning or swelling can result in fire. Transmitter Setup Program your transmitter before attempting to bind or fly the helicopter. When using a Futaba transmitter with a Spektrum DSM module, you must reverse the throttle channel and rebind. Refer to your Spektrum module manual for binding and failsafe instructions. Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.
Should you need to anlsitung the transmitter and receiver, follow the steps below. Rudder Control Test 1.
Step by step DX6 / DX9 for nano – HeliFreak
An,eitung any two main motor wires from the ESC. Power on the transmitter. Make sure the transmitter is in Normal Mode. Connect the flight battery to the ESC. Move the rudder control to the right. The tail rotor blades move as shown.
If they do not move as shown, reverse the rudder channel in the transmitter refer to your transmitter manual for instructions. Move the throttle hold switch to the ON position.
Disconnect the battery from the helicopter and reverse any two motor wire connections to the ESC. Adjusting the Drive Belt Tension Belt tension that is too tight results in loss of power and causes the belt to wear more quickly. Tension that is too loose can cause belt damage and loss of B Mozzo ingranaggio di autorotazione con BLH B C;x Aluminium Kabinenhaubenhalter Supports de bulle en aluminium: B Jeu de train d’atterrissage principal, noir: Set del carrello di atterraggio, nero: The Spektrum trademark is used with permission of Bachmann Industries, Inc.
Horizon Hobby Blade 200 SRX Instruction Manual
Also See for Blade 3D Instruction manual – 64 pages. Page of 24 Go. Table of Contents Add to my manuals Add.
Transmitter Setup Transmitter Setup Program your transmitter before attempting to anleotung or fly the helicopter. Comments to this Manuals Your Name. Enter text from picture: By pressing ‘print’ button you will print only current page. To print the manual completely, please, download it.
Don’t show me this message again. Got it, continue to print. Don’t have an account?