Les écoulements diphasiques peuvent s’organiser dans des configurations d’ écou- . pour l’amortissement diphasique dans les écoulements `a bulles et. Dans ce mémoire, on s’intéresse à la simulation des écoulements liquide-vapeur en transition de phase. Pour décrire ces écoulements, une approche bifluide. lumes Finis des écoulements diphasiques eau-vapeur. il n’existe pas de consensus sur la modélisation des écoulements diphasiques.

Author: Doudal Malanris
Country: Great Britain
Language: English (Spanish)
Genre: Software
Published (Last): 8 September 2010
Pages: 74
PDF File Size: 14.53 Mb
ePub File Size: 18.46 Mb
ISBN: 134-9-24137-547-3
Downloads: 20971
Price: Free* [*Free Regsitration Required]
Uploader: Shaktizshura

These course notes, presented at the The determination of the role of liquid films in three phase flows in porous media is very important for enhanced oil recovery by gas injection in a petroleum reservoir. These characteristics are fed into deterministic models that describe fluid flows.

An analysis and a comprehension of the relation between the geometrical and functional parameters with the flow pattern inside the header and the two phase distribution, has been established. Lors des phases de definition et de design preliminaires, des methodes rapides sont necessaires afin d’etudier les candidats efficacement.

This model suitably predetermines ecoulementa pressure gradient, the average gas content and the length of gas and liquid slug. Modelling of the flow in the interface of a composite liner at the bottom of a municipal waste landfill; Modelisation des ecoulements dans les interfaces des barrieres diphasiqes composites des installations de stockage de dechets. Bagnold; non-equilibrium particle configuration in sedimentation; unsteady screening of the long-range hydrodynamic interactions of settling particles; computer simulations of hydrodynamic interactions among a large collection of sedimenting poly-disperse particles; velocity fluctuations in a dilute ecouulements of rigid spheres sedimenting between vertical plates: A linear combination of momentum equations has been used in the axial and radial directions to avoid the source term of the equations to become singular.


Simulations results are then described and validated for a one-hole injector and a multi-hole injector, showing the code possibilities to get a better understanding of the liquid flow in an injector during the whole injection.

Several flow regimes for the two-phase mixing derive from this analysis. Par visualisation en strioscopie on observe les mouvements du film thermique associes a l’amorcage des germes, au depart et a la condensation des bulles; les mecanismes responsables de l’excellent transfert de chaleur ont pu ainsi etre precises.

Friday, April 9, – 1: We describe Level Set method which has been used to track interface motion, and numerical methods for solving Navier-Stokes equations. Secondly, the study of turbulent flow in the double shell reactor confirms the use of 2D axisymmetric geometry instead of 3D geometry to compute heat transfer.

Modeling and numerical analysis of non-equilibrium two-phase flows; Modelisation et analyse numerique des ecoulements diphasiques en desequilibre. Do not hesitate to show your support at their farewell party to be held on Monday 7 October, from 4 to 6 pm in front of the St Genis-Pouilly Mairie city Hall.

Analysis of transient flows in gasoline direct injection systems: The first chapter describes the equations of the local dual-fluid model for the 3-D description of two-phase flows.

On fait les calculs, avec des hypotheses simplificatrices, dans le cas de Melusine. The authors have therefore developed a method consisting of the introduction of a calculated amount of sodium into the boiler water.

There was a problem providing the content you requested

The second one relies on the simultaneous and one dimensional resolution of a turbulent boundary layer equation and a variance transport equation near the wall. The model is then applied to the simulation of a turbulent flow in a simplified model of a reactor core. Model development and validation examples. The temporal behaviour of two diphasiquess models algebraic and zonal wall models were studied and showed that a zonal model produced better results when used in the simulation of unsteady flows.


Using the volume averaging theory of Quintard and Whitaker, the local problem is replaced by a double-porosity large scale description. In order to describe these phase transition flows, a two-fluid two-pressure approach is considered. Cellular properties of slug flow in vertical co-current gas-liquid flow: L’existence d’un maximum pour les coefficients d’echange thermique et de perte de charge a ete constate lorsque le pas atteint huit fois la hauteur des rugosites.

Structure and kinematics of bubble flow; Structure et cinematique des ecoulements diphasiques a bulles. Supercritical water oxidation is an innovative process to treat organic liquid waste which uses supercritical water properties to mix efficiency the oxidant and the organic compounds.

The two-phase pipelining of a wet eckulements field production presents many advantages, especially from an economic point of view. At the microscopic scale, the reconstitution of crack opening – fluid percolation – crack sealing stages is delicate.

les ecoulements diphasiques: Topics by

Two-phase gas-liquid flows were analyzed so as to develop models for prediction of pressure drops in crude-oil production lines.

This diphasiwues studies heat and mass transfer characteristics of two phase He I in a natural circulation loop. Items 1 – 24 of The methods developed here may be extended to ionizing shocks.

In this work, we present two approaches to model faults from the mathematical point of view. We consider pressure diffusion in fractured media, with application to well test interpretation.